STRIPOL

Stripper for all waterproof and alkali-resistant floor coverings.

Highly effective cleanser for the removal of acrylic dispersion and dry-bright emulsion coats from floors. Also applicable as slightly alkaline all-purpose cleaner.


Application areas

For all washable floor coverings like plastics, PVC, hard concrete, terracotta slabs, clinker bricks, natural and synthetic stone, epoxy resin, rubber, Colovinyl and xylolite.


Dosage

As floor stripper: Add 1 – 2 l to 10 l water (10 - 20%).
As all-purpose cleaner and for stubborn dirt: Add 2 – 5 dl to 10 l water (2 - 5%).


Instructions for use

Apply solution.
Allow to act for approximately 15 minutes.
Scrub.
Possibly use a blue or brown pad.
Remove soiled solution with a wet vacuum cleaner or mop.


Product consumption

10 l solution for 30 - 50 m2.


Special advice

Immediately remove any splashes from painted or lacquered surfaces and skirting boards.
Rinse with clear water if a coat is applied after the treatment.
Exercise caution with linoleum and asphalt: do not overdose (maximum 10%).
Test the colourfastness of the materials in an inconspicuous place before the application.
The manufacturer declines all responsibility for damages from improper product use.


Technical data

Storage stability: at least 2 years
pH value (concentrated): 13.5
pH value (10% solution): 12.5
Ingredients: non-ionic surfactants, amines, solvents, complexing agent, perfume, water

Specific References