wood-seal 2K gloss
2-K sealant, water-based. For all untreated parquet floors. Glossy.
Water-dilutable, low-odor 1- or 2-component sealing lacquer on base of polyol. It results in viscoplastic, very wear resistant and non-yellowing rough surfaces seals. The resistance to water, alcohol and household chemicals is excellent. For increased requirements wood seal is treated with a special hardener (2-K), whereby the mechanical and chemical resistance is improved.
The sealer cannot be removed by a chemical deep cleaning!
Wood seal is suitable for wood and parquet.
Instructions for use
The surfaces to be sealed must be free of oil, wax and other impurities. If wood seal is used with the hardener, mix the hardener with the same amount of water and add this mixture thoroughly under stirring to the sealer. Repot over a filter and let it rest for 10 minutes. Make sure that the air and ground temperature during treatment is between 12 and 22 degrees and the humidity does not exceed 75%.
Pot life and working time is about 3 hours.
Life time is dependent on the layer thickness. Therefore 2 to 3 coats should be performed.
Application: Roller or brush
Mixing ratio: With hardener: 10: 1
Cleaning: Working equipment should be cleaned immediately with water.
Drying: - Dust-dry after about 45 minutes
- Recoating after approx 4-6 hours
- Walkable after 24 hours
- Fully hardened after 6 days (carpets etc. laying-up after this time)
The manufacturer declines all responsibility for damages from improper product use.
Storage stability: The product has tightly closed in its original container at least 1 year shelf life.
Storage: protect from frost
pH value: concentrated: 8,5
Ingredients: watersoluble polymers