sprayemulsion

For the cleaning and maintenance of floors with the spray method. Thanks to the special formulation, water-soluble and solvent-soluble dirt is removed in one single step. Provides a thin protective film. Especially suitable for areas where cleaning cannot be done with water or where work traffic should not be interrupted (e.g. hospitals, corridors).

Application areas

For all smooth floor coverings made of plastic, PVC, linoleum, synthetic and natural stone.

Dosage

Apply undiluted.

Instructions for use

Preparation: Damp mop the floor. Equip the single disc machine with a spray device and cleaning pad. Shake product container before filling product into the spray device.

Spot spray clean: Buff the floor once or several times per week. Sparingly spray product onto soiled areas and treat with the single disc machine and pad. After a short drying time, buff the cleaned surface areas with the same pad. If the pad begins to smear, use the clean reverse side or replace pad.

Full spray clean: Clean large surfaces in lanes of 2 – 3 m in width by sparingly and regularly spraying the product onto the floor and then treating the sprayed section with the single disc machine and pad. Guide the machine in circular motions; the pad will pick up the dissolved dirt. If the pad begins to smear, use the clean reverse side or replace pad. Buff the entire floor with a fine pad.

Product consumption

Partial spray cleaning: 1 – 3 g / m²
Full spray cleaning: 3 – 7 g / m²

Special advice

Soak pads in a lukewarm solution of an all-purpose cleaner immediately after use, rinse and allow drying.
Not suitable for use on asphalt and unsealed wood.
The manufacturer declines all responsibility for damages from improper product use.

Technical data

Storage stability: at least 2 years
pH value (concentrated): 8.5
Ingredients: surfactants, waxes, organic solvents, preservative, perfume, water