striponet

For the rapid spray buffing of coated floors with heavy and permanent traffic. Alternative to wet stripping. Suitable for false floors.

Striponet has been developed especially for machine cleaning without water. For floors with a hard maintenance coat. The product is very economical in the application. Quick drying makes this method perfect for stripping in high traffic areas without interrupting the daily routine. The floors can be polished or coated with acrylic dispersions or dry-bright emulsions immediately after the treatment.


Dosage

Apply undiluted.


Instructions for use

Preparation: Damp mop floors before use.

Application: Pour the product in a clean spray device of the single disc machine. Equip the machine with a suitable pad (according to the amount of soiling). Spray the product evenly onto the floor. Move the machine in circular motions un-til the floor is dry. If the pad smears, turn it and use the clean reverse side, or replace it.


Special advice

Large, broad surface areas should be divided in lanes of 1.5 – 2 m width.
It is recommended to use a white or red pad for the treatment.
Polish the protective film after the treatment.
In the case of heavy soiling, floors cleaned with striponet and a blue pad requires being stripped less often.
Apply a coat if necessary (depending on the protective film’s condition).
Recommended as stripper where cleaning with water is not possible.
Remove old maintenance films with a blue or brown pad and apply 1 - 2 acrylic dispersion coats.
Do not allow pads to dry, but soak them in a detergent solution and rinse thoroughly with lukewarm water.
The manufacturer declines all responsibility for damages from improper product use.


Technical data

Storage stability: at least 2 years
Storage: store in the original container
pH value (concentrated): 10
Ingredients: organic, water-soluble solvents, amphoteric surfactants, assistants, perfume

Specific References