strip-extra

Stripper for all waterproof and alkali-resistant floor coverings. Good cleaning performance. Solvent-free. Can also be used on linoleum.

Highly active cleanser for the removal of acrylic dispersion and dry-bright emulsion layers on floors. Also suitable for use as a general, slightly alkaline cleanser.


Application areas

For all washable floor coverings like plastic, PVC, linoleum, hard concrete, terracotta tiles, clinker bricks, natural and synthetic stone, epoxy resin, rubber, Colovinyl and xylolite.


Dosage

Add 0.5 – 2 l to 10 l water (5 - 20%).

For general cleaning and the removal of heavy soiling:
Add 2 – 5 dl to 10 l water (2 - 5%).


Instructions for use

Apply solution.
Allow to act for approximately 15 minutes.
Scrub (possibly with a blue or brown pad).
Remove soiled solution with a wet vacuum cleaner or mop.


Product consumption

10 l solution for 30 – 50 m2.


Special advice

Immediately remove any drops or splashes from painted / lacquered surfaces and skirting (baseboards) with water.
Rinse floors with clean water if a polish is applied after the treatment.
Do not use more than a 10% solution on light coloured linoleum or asphalt floors.
The manufacturer declines all responsibility for damages from improper product use.


Technical data

Storage stability: at least 2 years
pH value (concentrated): 12.5
pH value (1% solution): 10.5
Ingredients: surfactants, amines, phosphates, complexing agents, perfume, water

Specific References