ECO-ecofloor

Fresh care concentrate. For all waterproof floor coverings with or without coatings. Forms a slightly glossy, dirt-resistant and slip-resistant protective film which can be polished to a high-gloss finish.

A product which has been developed especially to meet the new demands in the area of cleaning and maintenance. Slip resistant. Complies with the DIN 18 032, paragraph 7.5 “Gleitsicherheit”. For all water-resistant coated and uncoated floor coverings. Readily biodegradable. The biodegradability is 98% within 14 days - according DOC analysis (OECD test 302B EMPA Test Report No. 454033E). This product meets all IGÖB criteria for environmental sustainability.


Application areas

For all washable floor coverings like plastic, PVC, linoleum, Colovinyl, PU, natural and synthetic stone, rubber and epoxy resin.

ECO-ecofloor is a product for versatile applications:

  • economical wet mopping
  • thorough spray cleaning
  • automatic scrubber use.


Instructions for use

Wet mopping: Add 0.5 - 2 dl to 10 l water. Apply solution with a wet mop, al-low to act briefly, remove soiled solution and allow floor to dry. Buffing increases the protective film's shine and tread resistance.

Spray cleaning: Use undiluted or 1:1 diluted.

Spot spray cleaning: Spray ECO-ecofloor onto the soiled floor areas and treat with a single disc machine and buffing pad. After a short time, buff the cleaned surface areas.

Full spray cleaning: Clean large surfaces in lanes of 2 - 2.5 m width by spraying ECO-ecofloor evenly onto the floor. Treat the sprayed section with a single disc machine, and then buff.

Automatic scrubbers: 0.5 - 2 dl to 10 l water.


Special advice

Not suitable for unsealed wood and unsealed cork floors.
The manufacturer declines all responsibility for damages from improper product use.


Technical data

Storage stability: at least 2 years
pH value (concentrated): 7.5
pH value (1% solution): 7
Ingredients: non-ionic surfactants, preservative, dye, perfume, water

Specific References